Product information "Cover"

The same aluminum covers are used for the basic profiles of the wall pillars, corner pillars, skirting ducts and flat wall pillars. There are two standard finishes (natural anodized and stainless steel). The covers are clipped onto the basic profiles without requiring screws. The covers are available with corresponding perforations for use with various installation products and light modules. A special design feature is the frameless installation of standard switch systems.

Application: High-quality cable trunking system
Conformity: Tested according to DIN EN 50085-2-1
Cover: Natural anodized aluminum (E6EV1)
Cut-out: 55 x 55 mm, 65 x 65 mm, 71 x 71 mm, Closed
Length: 900 mm
Number of cut-outs: 1, 2, 3, 4, 5
Product group: AmbienTech
Product category: Wall pillar
Made in Germany: Yes
  • Aluminum cover in the respective version
  • Installation instructions

0 of 0 reviews

Leave a review!

Share your experiences with others.

You might also be interested in this:

Skirting board duct
Skirting board | Skirting duct
Length: 625 mm
The AmbienTrack skirting board duct is mounted on the floor and is used for horizontal cable routing and for installing components close to the floor. On plasterboard walls, it is possible to partially integrate the skirting board duct into the wall. It has two shadow gaps that can be backlit with AmbienArt LED strips. Electrical installation system compliant with EN 50085

Skirting board
Skirting board | Skirting duct
Length: 1800 mm | PU: 1 pc.
The AmbienTrack skirting board replaces the usual skirting board. It is used to lay the cables horizontally in the room and to connect the AmbienTrack wall and corner pillars and the device supports. It can be mounted on the wall or flush with the surface. Electrical installation system compliant with EN 50085

Tool Box
Cut-out: Closed | Number of cut-outs: 2
Installation components such as switches, sockets, computer and multimedia connections, sensors and control elements can be installed in the AmbienTrack Tool Box in any desired combination: whether in the wall pillars, corner pillars or skirting ducts. In addition to this, the Tool Box can also be used as a distributor or junction box, and for installing electronic assemblies if required. The Tool Box is available in combinations of 1 to 5 units. Electrical installation system compliant with EN 50085.

Variants from €6.18*
End section for wall pillar
Molded parts